Translate

Showing posts with label Headlight fitting. Show all posts
Showing posts with label Headlight fitting. Show all posts

Saturday, September 3, 2011

More Fitting and Aligning

All right, I wasn't done.  Rivets, rivet holes, thinning fiberglass and general workmanship issues drove me back to the headlight buckets.  I marked the areas that needed attention...


then ground all the areas until the fiberglass was almost paper thin.


Those areas were then filled with fiberglass resin and matting.


After grinding the fiberglass, a thin coat of Bondo was applied...


then the front end was painted with 2 part epoxy primer.


Although I don't have pictures to support his effort, Ty spent several hours fitting the rear bumper area to perfection.


After all that hard work we loaded up the Corvette and took it to a local Friday night car show a few miles down the road.  It was a fun evening and several people stopped to talk about our project.


Oh yeah.  I got tired of people referring to my trailer as a POS so I made some minor modifications and gave it a fresh coat of paint.  I think it turned out great and I doubt Ty and Dennis will bad mouth it any more.


OK, so here's where we are.  There is one more repair that needs to be worked on before we can say "fit" is complete.  There is an interference between the right side A pillar and the passenger door that won't allow a chrome piece to be installed.  This interference can only be corrected by cutting and repositioning the A pillar.  Once this is repaired we can remove the body and start doing "finish" work.  Be forewarned, finish work will be a long process.

While the body is removed we will fix several items on the rolling chassis.  If you double click on the picture you'll see some of the things we need to do.

Check back in a couple weeks to see if the A pillar has been repaired.  Thanks for watching.