Translate

Showing posts with label A Pillar Modification. Show all posts
Showing posts with label A Pillar Modification. Show all posts

Friday, September 9, 2011

A Pillar Modification

When this A pillar was repaired over a year ago it was done without the benefit of the drip rail or the door being in place.  Now that the drip rail and door are hung/aligned we can see we don't have a gap between the door and the drip rail on the inside of the car.  An interior molding goes here so the gap must be increased.   


After examining all options we decided to modify the pillar in the area shown.  A gradual taper was needed starting at the mid point of the pillar working down to a 3/8" gap at the bottom.


The drip rail was removed then the pillar was cut using a thin cutting wheel.  The pillar was bent into its new position then prepared for welding.


Using dozens of tack welds the pillar was re-welded into place.


The tack welds were ground smooth then JB Weld was applied to fill in any nooks and crannies.


The drip rail was welded back in place then we check to see how everything fit.  We ended up with a nice even gap between the door and A pillar as viewed from outside the car.


And we have a respectable "3 tongue depressor" gap on the inside.  This will be perfect for that piece of molding.

Body removal should be next.  Stay tuned for that!