Weatherstripping our Doors

Installing weatherstripping on a door can be a very messy job, especially if the door is attached to the car.  Fortunately, our doors are not attached and we know a couple tricks.

The weatherstrip on a 1963 Corvette coupe is glued to the door.  There are no push pins, screws or clips.  We start the process by masking the door where the weatherstrip will go. 

That tape is then bordered by two more rows of masking tape as shown.

The first row of tape is removed then the paint is scuffed with Scotch Brite.

Weatherstrip adhesive is a contact cement that comes in two basic colors, traditional yellow and black.  We chose black because it matches the weatherstripping and it's hardly noticeable against our dark blue doors.

Adhesive was applied between the two rows of tape then allowed to dry for a few seconds.  All of the tape was then removed leaving a clean door with very little mess.

Adhesive was applied to the weatherstripping then the weatherstripping was glued to the door.  If you don't have a helper it's best to install the weatherstripping one section at a time.  It can get very messy.

3M General Purpose Adhesive Cleaner was used as a final step to wipe down the weatherstripping and the door.  This cleaner does a great job and it won't harm the painted finish.

Both doors are done and they turned out great.  Next we start aligning the doors.