"Dry Fit" and Drip Rails

Dry fit continues.  Since we didn't start with a fully assembled car we are not certain about how all the parts and pieces get assembled.  The dry fit process allows us to identify and fix things prior to paint.  Already we have found missing bolt holes (dash), too many holes (under the exterior rear view mirror), mis-located holes (drip rails), missing pieces (clutch linkage), malfunctioning pieces (hood hinge), alignment issues (dash to A pillar), and other similar issues.  All have been fixed, repaired or replaced as needed.  This effort continues and will be well worth it once we start the fit and finish process.

To complete the clutch assembly I needed a pin to connect the clutch pedal to the connecting rod located under the dash.  I was unable to find one on line so I fabricated one out of a stainless steel bolt using my bench top lathe.  The stepped section on the shaft was key to getting a good fit.

Last year I fabricated new drip rails for both doors but never got around to installing them.  Last week  I clamped the rails in place...

spot welded them from the inside...

fabricated drip rail shoes...

then welded both pieces together.

This is the old drip rail next to the new.  The new drip rails will be weather proofed when we do the fit and finish on the car. 

Brakes have been installed.  This is an original 1963 master cylinder that was purchased with the car.  It works great but I did manage to spill brake fluid on the firewall.  You can see where the fluid ate away the paint on the fire wall and exposed green primer.  This will be fixed when we disassemble the car for paint. 

The battery, expansion tank, and the Heater Delete block-off cap on the heater hose have been installed.  Although the battery fits, it is too tall.  A shorter battery will be installed later.

All of the tail lights and running lights have been installed.

The dash, steering wheel and seats have also been "dry fit".

Even the FI air cleaner has been installed.

Except for the windshield, we are ready to Fred Flintstone this thing.  Ty is out of town this week so we will wait until his return before we take this to the road.  That should be fun.  Stay tuned!!