The Doors - 1963

In early 1963 Chevrolet discovered that the roof panel was not being produced to specification.  It was too small.  The die was about .10" too small which made for a poor fit at the upper door to roof panel.  Later in 63 the die was chrome plated which helped but never fully corrected the problem.  This error occurred on all coupes from 1963 to 1967.   So the question is, do we want our coupe to be as it was when it came off the production line or do we want it as the designers intended.  We opted for the latter.

Tape was used on the upper door so that the Bondo could be easily removed from this area. We don't want the door any taller than it already is.

After hours of sanding we ended up with very nice results.

Both doors received the same treatment and both turned out equally well.

The door to body gap was worked until uniform.

This should look really nice once painted.

Click on this photo and check it out.  After a little more primer and a little more sanding the doors should look like they were cut from the body, just like the designer intended back in 1963.

The body will be removed next.  Guaranteed.  Thanks for watching.

Finish Work Begins

We decided to start the finish work on the doors before removing the body.  The reason is because our body dolly no longer supports the nose of the car and we thought that might alter the doors alignment.  I started with the passenger door because there is a spot that I suspect needs more than just Bondo.

I was right.  Using a burr grinder I removed old damaged fiberglass all the way down to bright metal.  The fiberglass was feathered back so that the repair would cover a large area.  The larger the area the stronger the repair.

Five layers of fiberglass matte were used to make that repair.  While the fiberglass was curing I started sanding the louver area.   All blemishes and questionable areas were removed by grinding.  In this picture the areas that still have green primer are shallow/low areas that require Bondo. 

The green primer was removed before applying the Bondo.  Bondo is intended to be applied directly over fiberglass and metal, not primer.

After the fiberglass resin and the Bondo cured, the area was block sanded until smooth.  The next time we work in this area it will be for fresh primer.

Ty was able to come over for a couple hours today.  Ty used the same basic technique on the front of the passenger door.  After sanding, the thickest amount of filler material is estimated at only 1/32".

The passenger door is  2/3 done.  As we continue to finish the car we will have less and less primer.  You can gauge our progress by watching the primer disappear.

So how did we do on our first day of finish work?  Ty and I think we did pretty good.  Double click on the picture to judge for yourself.

After cleaning up the mess we took a few minutes to admire the car.  There is shop talk about a white racing stripe.  What do you think?